Crosley CB22G6Q Manual Del Propietário página 4

Installation,
Remove Phillips
screws to remove
center hinge.
• Retain all screws
for later use.
Remove bottom hinge or stabilizing
bracket with 3 " hex head driver.
⁄
8
• Lift out bottom hinge pin.
• Retain hinge pin and screws for later
use.
How to reverse the
doors
Perform all steps listed in How to
Remove the Doors and Hinges.
Remove cabinet plugs with flat blade
screwdriver tip wrapped in masking
tape.
Transfer cabinet plugs and cabinet
screws to opposite side of cabinet.
Remove center mullion screws with
5 " hex head driver.
⁄
16
Remove bottom mullion screws with
hex head driver.
3
cont.
IMPORTANT: When working directly on
doors, place doors on a nonabrsive sur-
face protected by towels or rugs to avoid
damage to door finish.
Using a Phillips screwdriver, transfer
door stops from bottom edge of fresh
food and freezer door to opposite side
of door edge.
See How to Install and Remove
Handles to remove and reinstall han-
dles.
Proceed to How to Replace the
Doors and Hinges to mount doors.
Installing fresh food
front-mount handle
If installing handles for the first time, the
fresh food handle can be located within
the fresh food section. The handle trim
will be located in the literature package.
Remove
face with hex nut driver.
• If reversing door,
remove door plugs
from opposite side
of door and insert
3 "
⁄
8
in screw holes.
Align handle holes with screw holes
on door face and secure with 2 door
face screws previously removed.
1 " hex nut screws from door
⁄
4
Locate handle trim in literature pack
and install over top and bottom of han-
dle.
• Secure top handle trim with remain-
ing screw removed
previously.
• Snap bottom trim
over bottom portion
of handle.
Installing freezer
handle
If installing handle for the first time, the
freezer handle can be located in the
literature package inside the refrigerator.
Remove Phillips screws from top edge
of freezer door opposite hinge side.
• Retain screws for later replacement.
• If reversing freezer door, remove
door plugs from top edge of door and
insert into screw holes.
Align handle holes with screw holes
on door edge and secure with screws
previously removed.