Tabla de contenido
Assembly Instructions
Genuine parking distance control system, Volkswagen up!
Scope of delivery:
◆
1 x left sensor holder
◆
1 x middle sensor holder
◆
1 x right sensor holder
◆
3 x isolating ring
◆
3 x sensor
◆
1 x left cover cap
◆
1 x middle cover cap
◆
1 x right cover cap
◆
1 x control unit
Required special tools, test and measuring equipment and auxiliary equipment:
◆
Assembly tool for PDC holder -VAS 6614-
◆
Crimp grip pliers
◆
Vehicle diagnosis, measurement and information system -VAS 505X-
Installation process:
Note
◆
The Genuine Park Distance Control system should be fitted by an authorised workshop. Incorrect fitting may result
in damage to the vehicle or the Park Distance Control system.
◆
The Genuine Park Distance Control system is not suitable for fitting on vehicles which have subsequently been
lowered (sport suspension, etc.).
◆
The work to be performed on the vehicle, as described in these installation instructions, may vary in some
circumstances as a result of model improvement measures. As such, changes to the wiring colours or even the
fitting sites cannot be discounted. In view of this, please ensure that you always use the appropriate current circuit
diagram or the current vehicle workshop manual.
◆
All Genuine Park Distance Control system component, with the exception of the CAN-Bus/power supply wiring
harness, correspond to production status and are assembled at the factory-installed fitting location.
◆
All rights to make technical changes reserved.
1.1 Painting the sensors
Note
◆
Do not clean the sensors with a silicone remover prior to painting, use a mild alcohol instead.
◆
Additional general information concerning painting:
Self-study programme No. 214/215
Tape off the sensors so that only the visible outside surface of the sensors remains free.
Paint the outside surface of the sensors evenly and not too thickly the same colour as the car.
Repaint as necessary after drying, e. g. clear varnish for twin coat painting.
1.2 Assembly of sensors and bumper wiring harness
Exploded view:
Page 2 – Fig. 1
1 - Bumper cover
2 - Sensor with seal, holder and right cover cap
◆
Sensor 1S0 919 275
◆
Seal 1T0 919 133 C
◆
Sensor holder 1S0 919 492
◆
Cover cap 1S0 919 079 B
3 - Bumper wiring harness
◆
1S0 971 065 F
20
◆
1 x buzzer (tone generator)
◆
1 x bumper wiring harness
◆
1 x control unit/bumper wiring harness
◆
1 x CAN-Bus/power supply wiring harness
◆
2 x M6 hexagon nut
◆
2 x expanding rivet
◆
14x cable ties
◆
3 x crimp duraseal connector
◆
1 x installation instructions
◆
Wiring harness repair kit -VAS 1978-
◆
Cleaning solution D 009 401 04
1S0 054 630
Tabla de contenido
