Back of Vanity
Floor
3. Flush-Mount the Vanities - Optional
CAUTION: Risk of Personal Injury. Do not attempt to lift
the vanity into place without assistance.
Set the vanities down on a soft, clean area. The vanities should be
oriented as illustrated.
NOTE: To avoid damaging the wood surface, place a soft cloth at
the adjoining side of the vanity before attaching the C-clamp.
Align the adjoining side of the vanities to achieve level and
ensure plumb. Use a C-clamp to hold this alignment.
IMPORTANT! Do not fully drive the connection screws through the
finished surface of the adjoining vanity. The combined thickness of
both vanities at the adjoining side is 3/4" (1.9 cm).
Partially drive three 1-1/4" connection screws (not provided)
through the pre-drilled holes at the adjoining side of the vanities.
Remove the C-clamp and soft cloth.
1055673-2-C
Pilot Holes
C-Clamp
1-1/4" (3.2 cm)
Connection Screws
6
Kohler Co.