Dyna-Glo DGJ810CSB-D Manual De Instrucciones página 26

OPERATING INSTRUCTIONS
lighting the Gas Grill
Do not lean over grill when lighting. Read instructions before lighting.
1. Check that the control knobs are in the O "OFF" position.
2. Open valve at tank fully by turning counterclockwise
3. Open lid during lighting.
4. Push igniter down 3 to 4 seconds while turning desired main control knob to the
The burner should ignite.
5. Repeat for all other burners. If ignition does not take place within 5 seconds, immediately turn the
control knob to the O "OFF" position. Wait 5 minutes and repeat step 4 above or refer to match
lighting instructions below.
If the burner still does not light, check that there is gas in the cylinder and follow the match lighting
instructions.
lighting the Gas Grill with a Match
1. Open the lid.
2. Insert a match in the end of the match holder that is
installed on the right side of the firebox.
3. Light the match.
4. Immediately place the lit match through the spaces in
the grill grates near the ports of the burner between the
heat tents as shown. Make sure the lit match is close to
the burner ports.
5. Press in the control knob that operates the burner and
rotate counter-clockwise
Burner should light immediately.
6. Repeat steps 2 - 5 to light the remaining burners. If
burners do not light within 5 seconds, turn all control
knobs to the O "OFF" position and wait 5 minutes.
Repeat steps 2 - 5 until all burners are lit.
7. Adjust burners to desired cooking settings.
Shutdown Instructions
1. Turn control knobs clockwise
2. Close valve at tank fully by turning
3. Close lid.
Turn off LP supply at cylinder when appliance is not in use.
WARNING
to "HIGH" position.
to the O "OFF" position.
clockwise.
26
.
"HIGH" position.