Laminating - Olympia A 296 Manual De Instrucciones

Laminating

1 Connect the power cable to an easily accessible, standard electrical
socket.
Attention: Check that the voltage specifications of the unit corres
pond to that of your power supply network (220 - 240 V, 50 Hz).
2 Switch on the On/Off switch on the right-hand side of the unit: The red
"ON" control lamp lights up.
3 Set the foil thickness switch according to the foil pocket used:
I = 75 – 100 micron
II = 125 micron
4 The drive motor for the transport rollers starts up. The correct operat-
ing temperature is reached after about 5 minutes and the green indi-
cator lamp (READY) lights up.
5 Insert the document to be laminated in the foil pocket so that there is a
margin of approx. 3 - 5 mm to the edge of the foil on all sides.
Attention: Only use hot laminating pockets.
6 Insert the foil pocket containing the document in the laminator's inser-
tion slot. Insert the ready closed side of the foil in first.
Note: To prevent the laminating foil from creasing, never feed the
open side of the laminating pocket first in the insertion slot of the lami-
nator. When inserting the foil, observe the instructions on the insertion
slot. The laminating process occurs automatically.
Attention: The foil is very hot and soft when ejected following lamina-
tion. Therefore, handle the laminated product with extreme care.
Note: To flatten the laminated product, place a book or similar heavy,
flat object, on it.
14