Operation Instructions - Urrea LP807A Manual De Usuario

FITTING "D" AUXILIARY HANDLE
Always install the auxiliary handle on the tool
before operation (Fig.1).
Fig.1
Positions: 2 (Left & Right)
Hold the tool's switch handle and the auxiliary
handle firmly with both hands during installa-
tion. Hold in the auxiliary handle in position
and aim at hole in the gear box. Install the
bolts and tighten them with the hex wrench.
The auxiliary handle can be installed in two dif-
ferent directions; whichever is convenient for
your work (left & right).
FITTING POLISHING DISC AND WOOLEN
PAD
CAUTION: Always be sure that the tool is
switched off and unplugged before adjusting
or checking function on the tool.
Fig.2
How to change and
install wool bonnet
5
4
3
2
1
spindle cannot revolve, then with spanner (4)
tighten clockwise the polishing disc. Install the
wool bonet (5) by simply put the woolen pad
over the polishing disc. Let it operate for more
than three minutes for checking it up without
load.
10
3
1
4
2
1
Press the spindle lock
button (1) to prevent
spindle (2) rotation
when installing or re-
moving accessories.
Place the polish-
ing plate (3) on the
spindle and rotate
clockwise, then press
the spindle lock but-
ton firmly so that the

OPERATION INSTRUCTIONS

BEFORE START OPERATION
SHAFT LOCK
CAUTION: Always be sure that the tool is
switched off and unplugged before adjusting
or checking function on the tool.
CAUTION: Never actuate the shaft lock
when the spindle is moving. The tool may
be damaged. Press the shaft lock to prevent
spindle rotation when installing or removing
accessories.
SWITCH ACTION (Fig.3)
Switch can be locked in "ON" position for ease
of operator comfort during extended use. Ap-
ply caution when locking tool in "ON" position
and maintain firm grasp on tool.
Fig.3
To start the tool, simply pull the switch trigger.
Tool speed is increased by increasing pressure
on the switch trigger.
Release the switch trigger to stop.
For continuous operation, pull the switch trig-
ger and then push in the lock button.
To stop the tool from the locked position, pull
the switch trigger fully, then release it.
SPEED ADJUSTING DIAL
1
Higher speed is obtained when the dial is
turned in the direction of number 3000.
And lower speed is obtained when it is turned
in the direction of number 1000.
The number setting on the dial equal to the
tool speed.
CAUTION: If the tool is operated continu-
ously at low speeds for a long time, the motor
Lock button
Switch
The tool speed can
be changed by turn-
ing the speed adjust-
ing dial (1) to a given
number setting from
1000 to 3000. (At the
time when the switch
trigger is fully pulled.)