Tabla de contenido
Idiomas disponibles
Idiomas disponibles
USE
Selecting The Correct Size:
In order to ensure you choose the correct size Tarmac 2 Boot please see the table below
Men's Sizes
EU
41
42
US
8
8.5
UK
7.5
8
PPE Position And Fit:
For PPE to offer the maximum protection possible PPE must be placed on the areas to be protected and PPE must cover the protected areas
effectively. If the protective features are already incorporated into the PPE, then to be positioned correctly, the PPE must be the correct size. In all
cases, the proper equipment has been supplied to keep this PPE firmly in contact with the body.
Footwear:
Protective footwear fit is very important. The fit of different protective footwear styles varies due to differences in design and construction. Only use
protective footwear that fits properly. Any protective footwear that does not fit properly should not be used. Be sure that the protective footwear fits
snugly but not too tightly. Confirm that heel lift is minimal. Check to confirm adequate room in the toe box.
Wearing Instructions and Adjustment:
Repeat for each boot: Release the ankle retention strap, on the inside of the boot, at the ankle. To do this, grasp the tab at the end of the ankle
retention strap and then pull the retention strap away from the inside of the ankle, releasing the hook and loop fastener. The tongue of the boot is held
in place with permanently fixed elastic cords that run through it. Pull the tongue forward, stretching the elastic cords far enough to allow the foot to
be inserted into the boot. Insert foot, pulling the boot on. Slide foot all the way down in the boot. Confirm boot fit. Boot should feel snug on foot but
not too tight. Foot should be the same length as the boot without being too much shorter or too much longer than the boot. The permanently fixed
elastic cords running through the tongue adjust the fit of the boot automatically. Next, reengage the ankle retention strap. Grasp the tab at the end
of the ankle retention strap and wrap the strap around the front of the boot to the inside of the ankle and then reengage the hook and loop fastener.
Be sure to confirm that no pants or sock material is caught in the hook and loop fastener. The ankle retention strap may be adjusted by releasing
the ankle retention strap as above and then repositioning the ankle retention strap tab and reengaging the hook and loop fastener, with the tab in a
different position. Be sure that the ankle retention strap is snug enough to keep the boots on the feet but not so tight that it impairs blood circulation
or the foot's range of motion. Be sure that the hook and loop fastener is completely engaged and that the ankle retention strap tab is flat against the
boot. Check to confirm that wearing these boots does not reduce your ability to operate the motorcycle controls.
For maximum protection and safety the protective footwear should not cause any discomfort and should not reduce the rider's freedom of movement
or restrict the reach to, or operation of, the motorcycle controls while in a normal riding position. If you are unable to find a proper fit in this protective
footwear style, please try another CE certified protective footwear style.
04
43
43.5
44
9
9.5
10
8.5
9
9.5
44.5
45
45.5
10.5
11
11.5
10
10.5
11
46
47
48.5
12
13
14
11.5
12.5
13.5
Tabla de contenido
