Utilitech 7105-06 Manual Del Usuario página 11

EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS
9. Plug in LED panel (B) into the fan housing (A).
Plug in wire connectors (two hole and four hole) from fan
motor into fan housing.
10. Secure the LED panel (B) to the fan housing (A) using
4 long machine screws (BB) and metal washers (DD).
Hardware Used
BB
Long machine screw
DD
Metal washer
11. Choose which rim (C) finish suits your room. Lay glass
globe (D) into chosen rim (C).
12. Line up the three notches around the outside of the LED
panel (B) with the three clips on the rim (C). Gently push
up the rim (C) and glass globe (D) as far as possible until
it stops.
13. Rotate the rim (C) until it hits the stop and cannot be
rotated any further. Slowly pull hands away and glass
globe (D) and rim (C) will be attached to the fan housing
(A).
7
LED
connector
10
x 4
x 4
11
12
13
D
11
C
Notch
Clip
Clip
Notch
Clip
4
holes
2
holes
D
Notch
A
C