English; Steam Function - Braun steam & style pro 3536 Manual De Instrucciones

English

Our products are developed to meet the highest
standards of quality, functionality and design. We
hope you thoroughly enjoy the new Braun ap-
pliance. Carefully read the use instructions before
use.
Braun steam & style pro with integrated steam
function is suitable for pre-drying wet hair and
styling towel dry or damp hair as well as for styling
and refreshing dry hair.
Important
• Plug your appliance into an alternating current
outlet only and make sure that your household
voltage corresponds to the voltage marked on
your appliance.
• This appliance must never be used near
water (e.g. a filled wash basin, bathtub
or shower).
Do not allow the appliance to become
wet.
• Never fill water directly in the heating tube.
• For additional protection, it is advisable to
install a residual current device (RCD) with a
rated residual operating current not exceeding
30mA in the electrical circuit of your bath-
room. Ask your installer for advice.
• Do not wrap the mains cord around the ap-
pliance. Regularly check the mains cord for
wear or damage. The mains cord of the ap-
pliance may only be replaced by an authorised
Braun Service Centre. Unqualified repair work
can lead to extreme hazards for the user.
• Always unplug after use. If plugged in, the
appliance will continue to heat even on the
« »-setting. Even switched off, the appli-
ance presents a hazard when near water.
• The maximum environmental temperature for
operating the appliance is 30 °C.
Description
a Water reservoir
b Release button for attachments
c Switch ring (works with warm or cold air,
depending on the setting):
= Heating system for the steam function
is activated and working after approx.
2 minutes.
«1» = Warm air setting to style a medium and
small amount of hair and to create
volume at the roots.
«2» = Drying/styling setting to style a big
amount of hair.
8
«3» = Power setting for fast pre-drying wet hair,
especially with the volumizer attachment
(only with steam & style pro).
= Cool shot setting for styles to
last longer (is activated on all
settings («1», «2», «3») when
pulling and holding the switch
1 2 3
ring).
d Removable filter
e Power control light
f Hanging hook
g Big brush attachment
h Small brush attachment
i Volumizer attachment
(only with steam & style pro)
Before use
Each time before filling with water unplug the
appliance.
1 Pull the water reservoir off the appliance
(illustr. 1).
2 Turn to open the water reservoir (illustr. 2).
3 Fill the water reservoir with tap water to the
top of the black rubber ring and close tight the
water reservoir (illustr. 3).
4 Re-insert the water reservoir until it snaps into
place (illustr. 4).
5 Plug into an electrical outlet. The power con-
trol light lights up. Let the appliance heat up
on the « »-setting. Ready for steaming after
2 minutes (illustr. 5).
After use
Always empty the water reservoir.
Styling
• Big brush attachment for big curls
• Small brush attachment for medium and small
curls
• Volumizer attachment
(only with steam & style pro)

Steam function

The steam function can be used with all attach-
ments. To add steam to a streak of hair press the
top of the water reservoir (you will hear a click).
Steam will be released from the openings of the
tong, giving the hair additional heat and just the
required amount of natural moisture for a longer
lasting style.