List Of Parts; Harness Adjustment - Cosatto ZOOMI Guía De Instrucciones

operation:

1 - list of parts

Your child car seat is supplied in one carton and contains:
1. Head rest
2. Head cushion
3. Upper seat liner
4. Chest pad x2
2 - child car seat assembly
Push the adjuster button (a) located under the seat cover flap then pull the harness adjuster strap
until the back rest is in line with the booster seat.
Clip the back rest onto the booster seat (b).
The head rest can be adjust by pulling the lever (c) on the head rest out then lift to raise or push
down to lower the head rest to the desired height.
3 - approved seat belt requirement
WARNING: Your child car seat can only be installed forward facing using a three point
lap and diagonal belt in the front or rear passenger seats of the car.

4 - harness adjustment

The shoulder straps must be threaded through the slots in the head cushion, cover and seat
nearest the top of the child shoulders. If in any doubt always use the slot above the shoulder
rather than below it. However, once you reach the top slots your child may continue to use the
seat until their eye line is above the top of the seat shell or their weight exceeds 18Kg.
To move the shoulder strap from one slot to another loosen the harness by pushing the adjuster
button (a) in as you pull the shoulder straps forward as much as possible (b).
At the back of the seat, unclip the shoulder straps from the connector (c).
Feed the strap ends through the seat until they are clear of the cover (d).
Re-thread the shoulder strap back through your chosen shoulder slot in the seat (e). Make sure it
is not twisted. Repeat on the other shoulder strap.
Hook the shoulder straps back onto the connector (f).
Pull the adjustment strap forward to remove any slack (g).
5 - installation of the car seat 9-18kg (approx 9 months-4 years old)
Note: The illustrations show with cushions ghosted.
Place the child car seat in the forward facing position on the car seat.
Pull the vehicle seat belt and thread the diagonal belt through the red fabric seat belt slot (a) and
the lap strap under the seat belt guide (b). The seat belt slot is marked by a red arrow on a tag. At
the back of the seat feed the seat belt under the harness and through the other seat belt slot (c).
Pass the seat belt under the other seat belt guide (d) then fasten the seat belt. Locate the seat belt
in the slot under the headrest (e). The headrest slot is marked by a red arrow on a tag.
Carefully kneel on the child car seat to push it into the seat of the vehicle. Pull the seat belt at (f)
to tighten the lap section of the belt then pull the diagonal section of the seat belt tight at (g).
The child car seat should now be secure.
IMPORTANT: The position of the seat belt/lap strap buckle can affect the stability of the child
car seat. In an accident this could stop the child car seat from protecting your child as well as it
should. If, when the seat belt/lap strap belt is properly tightened, the buckle lies in the position
marked then try fitting the child car seat in another seating position in your vehicle.
5. Safety harness
6. Crotch pad
7. Lower seat liner
8. Booster seat
9. Adjustment strap
10. Harness connector