Protection Against Manipulation - BKS B-55600-20-1-8 Manual De Instrucciones Y De Montaje

Installation and operating instructions
B-55600-20-1-8 | B-55600-20-4-8 | B-55600-23-1-8 | B-55600-23-4-8
Fingerprint scanner and code keypad
3.5
Your system consists of 2 electronic devices:
„ „ Fingerprint scanner and code keypad
„ „ SECUREconnect 200 (control unit)
The fingerprint scanner and the code keypad are generally mounted in the
external area (on the outside of the door). To prevent unauthorised access,
your system is equipped with the following security functions:
„ „ The fingerprint scanner and code keypad are connected to the control
unit using a data cable. Data transmission is encrypted.
„ „ The fingerprint scanner and code keypad are paired for initial start-up.
In order to exchange a component of the door system (SECUREconnect 200R,
SECUREconnect 200F or fingerprint scanner/code keypad), you have to start
a re-pairing procedure. To do so, close the reset contact on the board of the
SECUREconnect 200F or SECUREconnect 200R for a minimum of 3 seconds
with the power supply connected. We recommend to use an alligator clip.
Then remove the clip. SECUREconnect 200R, SECUREconnect 200F and the
fingerprint scanner/code keypad start a re-pairing procedure. The finger-
print scanner and the code keypad is reset to the factory setting (all saved
finger templates and PIN codes are deleted).
If a fingerprint scanner and a code keypad are connected to an unpaired
SECUREconnect 200, a new system key is generated and the finger templa-
tes and the PIN codes are deleted.
EN
56

Protection against manipulation

07.2017 | XX | Designed in Germany