Blade Maintenance; Environmental Protection - Worx WG801E Manual Original

ASSEMBLY & OPERATION
ACTION
ASSEMBLY (Fitting/Changing the
blade)
Removing the blade
Warning: Wear gloves when changing
the blade.
Fitting the blade
Fitting and removing the weeder blade
BEFORE OPERATION
Checking the battery condition (Only
for WG801E/WG801E.1/WG801E.2/
WG801E.3/WG801E.4/WG801E.5)
Charging the battery pack
More details can be found in charger's
manual
Installing the battery pack
Removing the battery pack
OPERATION
Starting& Stopping
Trimming grass
NOTE: Keep the tool away from hard
objects and delicate plants. To make a
14
closer cut, slightly tilt the tool.
Trimming hedges and shrubs
NOTE: Take care to avoid any foreign
objects. Especially avoid hard objects
such as metal wire and railings, as
these could damage the blades.
Weeding grass
NOTE: To ensure efficient operation,
blade cleaning should be performed in
time after each work.
Operating with the telescopic handle
(Only for WG801E.1 WG801E.3)
Assembling/removing the telescopic
handle
NOTE:
-Install the battery pack first before
assembling the telescopic handle.
-Make sure the telescopic handle is
locked into position securely before
operation.
-Keep hands away from the on/off
switch when attach or remove the
telescopic handle to prevent accidental
start.
Adjusting the handle length
NOTE: The locking knob is used to hold
the handle in position at any extended
length.
Cordless shrub shear /
grass shear / weeder
Adjusting the cutting height
NOTE: The telescopic handle has two
FIGURE
cutting height levels (25mm &43mm).
Starting and stopping with the
telescopic handle
Warning: Do not use the shrub
See Fig.
shear blades (12cm/20cm) when
A1, A2
working with the telescopic handle.
See Fig.
B1, B2
MAINTENANCE
See Fig.
B3, B4
NOTE: To ensure long and reliable service, carry out
the following maintenance regularly.
Remove the battery before carrying out any
adjustment, servicing or maintenance.
See Fig. C1
Check for obvious defects such as loose, dislodged or
damaged blade, loose fixings and worn or damaged
components.
See Fig.
Check that covers and guards are undamaged and
C2,C3
correctly fitted. Carry out necessary maintenance or
repairs before using.
See Fig. C4

BLADE MAINTENANCE

See Fig. C5
Always clean the cutting blades after operation and
periodically lubricating the cutting blade.
See Fig. D
Visually check the condition of the cutting edges of
the cutting blade.
Ensure that the blade is covered with the blade guard
See Fig. E
supplied when not in use.
CLEANING/STORAGE
See Fig. F
Clean the exterior of the machine thoroughly using
a soft brush and cloth. Do not use water, solvents
or polishes. Remove all debris, especially from the
ventilation slots.
Store the machine in a secure dry place out of reach
See Fig. G
of children. Do not place other objects on top of the
machine.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
See Fig.
or retailer for recycling advice.
H1, H2
See Fig. I
See Fig.
J1, J2
See Fig. K
EN