Troubleshooting; Maintenance; Environmental Protection - Worx WX177 Traducción De Las Instrucciones Originales

5. TROUBLESHOOTING

1). THE DRILL DOES NOT TURN ON WHEN THE ON/
OFF SWITCH TRIGGER IS PULLED?
The Forward/Reverse Rotation Control, which is
above the trigger, is positioned in the lock function.
Unlock the Forward/Reverse Rotation Control by
putting it into the required rotation position. Push the
trigger and the drill will start to rotate.
2). REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Inappropriate charging time or leaving the Battery
Pack without using for a prolonged time will reduce
the Battery Pack capacity. This can be corrected
by charging & working with your drill several times.
Heavy working conditions such as driving large
screws into hard wood will use up the Battery
Pack energy faster than that in lighter working
conditions. Do not re-charge your Battery Pack below
0°C(32°F) and above 45°C (113°F) as this will affect
performance.
The ambient temperature range for the use and
storage of tool and battery is 0°C-45°C.
The recommended ambient temperature range for
the charging system during charging is 0°C-40°C.
3). THE DRILL CHUCK DOES NOT ACCEPT A
DRILLING OR DRIVING BIT?
14 14
The SWITCHDRIVER is equipped with dual 6.35mm
hex
drive chucks and will only accept bits with a 6.35mm
hex
shank.
4). WHY DOES THE DRILL NOT WORK AFTER
ROTATING THE DUAL CHUCK?
The drill can work only when the Dual Chucks
Rotating Plate is in right position as shown in Fig. B2.
When the Dual Chucks Rotating Plate reaches proper
position, you can hear a "click" sound.
20V Cordless Brushless
SWITCHDRIVER 2.0

6. MAINTENANCE

Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
7. ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.
EN