Citizen CT-S801II Manual De Usuario página 40

3.9 Setting the DIP Switch on the Serial
Interface Boar d
1. Turn off the prin ter and unplug the power cord from the electric outlet.
2. Remove the mou nting screws of the serial interface board.
3. Remove the serial interfa ce board from the printer.
4. Set the DIP switch according to the follow ing table.
Serial interface board mounting screws
CAUTION
When setting the DIP switch, do not remove any screws except the serial interface board
mounting screws.
The function of each switch is shown below. (Shaded values are factory
settings. However, factory settings differ depending on the destination market.)
Switch no.
1 Communication
condition setting
2 Hand shake
3 Bit length
4 Parity check
5 Parity selection
6
Baud rate
selection
7
8 INIT
Baud rate selection
When switch no. 1 is set to OFF, you can use a command or a memory switch
to select 1200, 38400, 57600, or 115200 bps.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
Function
According to DIP switch settings
Baud rate (bps)
2400
4800
9600
19200
V10 CONSUMIBLES S.L.
ON
XON/XOFF
7 bits
Yes
Even parity
Refer to table below.
Reset
6
OFF
ON
OFF
ON
— 36 —
DIP switch
OFF
According to memory switch
settings
DTR/DSR
8 bits
No
Odd parity
Invalid
Switch no.
7
OFF
OFF
ON
ON