Electrical Connection - Novellini DIVINA DUAL Manual De Instalación, Uso Y Mantenimiento

Electrical connection:

The manufacturer guarantees compliance to the current safety and health regulations at the time
of sale, through the CE mark and the declaration of compliance. All of the parts and components are
factory inspected as described in the reference standards and according to the company's quality
management system. For the safety characteristics to remain unchanged following installation and
during the entire lifetime of the tub, please follow the simple instructions provided.
1) Make certain that the electric system to which the tub will be connected has been installed
according to current regulations and standards, with special care for the ground connection.
2) The current standards prohibit electric installations (outlets, switches, etc.) in an area around
the tub for a distance of at least 60 cm and a height of 225 cm.
3) Check that the electric cable that powers the tub is sized correctly according to the power
indicated (please see the technical characteristics on page 33).
4) The tub's connection point to the electric system must be installed so as to be protected from
splashing water (IP protection rating IP55 or greater).
5) Upstream from the tub in the electric system there must be a 30 mA differential circuit breaker
with an omnipolar switch with a minimum opening of 3 mm between the contacts.
6) There is a ground terminal on the tub which must be connected to the ground circuit for the
supplemental equipotential connection between the metal masses in the tub
the figure on page 29-30-31-32).
7) The whirlpool baths is provided with electrical connection of the type Y, if the power cord is
damaged, it must be replaced by the manufacturer or by its technical assistance service or in
any case a person with similar qualification, so as to prevent any risk.
equipotentiality
-7-
ENGLISH
(please see