Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2
Install Shield and Gear Housing
Assembly
1. Install the gear housing and shield assembly.
2. Align the gear housing on the drive shaft and install the locating
screw (B).
3. Tighten the two (2) side clamping screws (A).
IMPORTANT
Flat edge of washers (C) must be against drive shaft.
Balance Unit
1. Put on harness and attach unit to harness.
2. Slide harness clamp up and down until unit balances with
head approximately 2 - 3 in. from the ground.
3. Tighten clamp screw.
NOTE
In case of Emergency, the trimmer/brushcutter can be released from
the harness by pulling up on the quick-release collar.
TO USE
THESE BLADES
Handle
You
must
Debris Shield
install
Harness
these
parts!
Blade
Mounting
Hardware
*
WARNING! DO NOT INSTALL BLADES ON GT (CURVED SHAFT) MODEL TRIMMERS
**
Arbor diameter of Upper Blade Plate must match arbor diameter of metal blades.
*** New cotter pin required each time blade is installed.
**** Brushcutters over 16.5 lbs (7.5 kg) dry weight (weight w/o fuel) require a double shoulder harness
SRM/PAS/SB BLADE SET-UP GUIDE*
Pro Maxi-Cut
Rigid Plastic
Grass/Weed
Tri-Cut
Plastic Cutters
Grass/Weed Blade
Loop Handle
Loop Handle, w/or
w/Barrier Bar,
w/o Barrier Bar
or U-Handle
Metal Shield
Metal Shield
Shoulder Harness
Shoulder Harness
Upper Plate &
Upper Plate
Flat Washer
& Glide Cup
Hex Nut
Hex Nut
New Cotter Pin***
New Cotter Pin***
C
Metal
Metal 80T Brush Blade
Tri-Cut/8 Tooth
Metal 22T Clearing Saw Blade
Grass/Weed Blade
Loop Handle
w/Barrier Bar,
or U-Handle
Metal Shield
Shoulder Harness
Shoulder Harness****
Upper/Lower
Blade Plates**
Blade Plates**
Hex Nut
New Cotter Pin***
New Cotter Pin***
A
B
C
2 - 3"
U-Handle
Metal Shield
Upper/Lower
Hex Nut
Tabla de contenido
