Echo 99944200002 Instrucciones De Instalación

For Models: GT-230/231, SRM-230/231, SRM-230S/231S, SRM-230U/231U, SRM-260/261,
SRM-260S/261S, SRM-260U/261U, PAS-230/231, PAS-260/261, PE-230/231,
PE-260/261, SHC-260/261, HCA-260/261, PPT-230/231, PPT-260/261
If you are unsure or are not equipped with the necessary tools, you may want to take your unit to an Echo
Service Dealer for installation of this kit. To help you decide whether you want to DO-IT-YOURSELF or have an
Echo dealer install this kit, we have rated this procedure as a SKILL LEVEL 2, which means some mechanical
experience and basic knowledge in the use of hand tools is necessary.
The Echo I-Start system is a starter accessory that will make your Echo unit easier to start by reducing the
pulling force by 75%.
If after reading these instructions, you are not sure of your ability to safely complete the installation, Echo
recommends you return the unit to your Echo dealer for service.
NOTE:
Carefully follow all assembly instructions, in sequence, in order to avoid damage to the I-Start components.
Tools Needed: 13mm Socket and Ratchet, Spark Plug Wrench, Cross Head Screwdriver, 3mm Hex Wrench,
Pliers, 3 X 1/4 in. Plastic Dowel Piston Stop similar to tooth brush handle (Recommended
Echo Piston Stop Part Number 91017).
i
Contents: - Start Assembly, Two Pawl Catcher, Starter Spacer, 3-Tapping Screws, Square Nut,
Instruction Sheet
I
NSTALLATION
:
DISASSEMBLY
1. Move stop switch to stop position.
2. Disconnect spark plug lead and remove spark plug with
spark plug wrench.
3. Remove four (4) starter screws and bottom engine stand to
starter screw, turning counter clockwise (CCW). Retain
screws for reassembly.
NOTE:
Starter screws have thread lock compound and may be
difficult to remove. To prevent damaging screws, turn screws
½ turn CCW then ¼ turn clockwise (CW). Repeat procedure
until screws are removed.
4. Lift starter assembly from engine.
5. Insert piston stop into spark plug hole. Rotate pawl catcher
CCW until piston rests firmly against piston stop preventing
crankshaft from further rotation.
6. Use 13mm socket to remove pawl catcher from crankshaft,
turning CCW.
7. Use pliers to clamp pawl catcher, then turn CCW to
remove.
NOTE:
Do not use excessive force when clamping pawl catcher to
avoid damage to assembly.
- S K
TART
I /O
NSTALLATION PERATING
P/N 99944200002
IT
I
NSTRUCTIONS
X7532093700
X753001310
02/04