Tabla de contenido
3
PLACE DOUBLEHAUL ONTO YOUR CROSSBARS.
• Consider rear-hatch access when
choosing your position.
• With assistance from a friend,
carefully place and position
DoubleHaul on your crossbars.
• Slide the plates so they are
centered over your crossbars.
• Continue to support DoubleHaul
as necessary until the mounts have
been fully tightened in the next step!
Do not allow DoubleHaul to tip
and damage your vehicle!
4
ATTACH THE MOUNTING HARDWARE.
Guide the clamps
around the crossbar
and up through the
mounting plates,
then attach and
tighten the knobs
to 2 Nm. The
knobs must be
oriented as shown.
Then tighten the
thumbscrew (make
sure the bolt is
captured in the
underside channel).
Note: For mounting on 2"
round or 2" square steel tubing,
remove the plastic bails from
the U-bolts before assembling
the clamping system.
5
TEST THE INSTALLATION.
Test the installation by pulling and pushing in all
directions. The DoubleHaul should not slide or move
on the crossbars. Re-tighten the knobs if necessary.
Instruction #1035940E - Page 3 of 9
2X
27" (686 mm) Minimum
4X
2X
2X
2X
2 Nm
8X
Tabla de contenido
