Panel Mounting - Rockwell Automation MicroLogix 1200 Manual Del Usuario

To remove your controller from the DIN rail:
1. Place a flat-blade screwdriver in the DIN rail latch at the bottom of the
controller.
2. Holding the controller, pry downward on the latch until the latch locks in the
open position.
3. Repeat steps 1 and 2 for the second DIN rail latch.
4. Unhook the top of the DIN rail slot from the rail.
open

Panel Mounting

Mount to panel using #8 or M4 screws. To install your controller using mounting
screws:
1. Remove the mounting template from inside the back cover of this document.
2. Secure the template to the mounting surface. (Make sure your controller is
spaced properly. See Controller Spacing on page 9.)
3. Drill holes through the template.
4. Remove the mounting template.
5. Mount the controller.
6. Leave the protective debris strip in place until you are finished wiring the
controller and any other devices.
Mounting Template
MicroLogix™ 1200 Programmable Controllers
closed
11
1762-IN006A-ML-P