Rockwell Automation MicroLogix 1200 Manual Del Usuario página 10

10 MicroLogix™ 1200 Programmable Controllers
DIN Rail Mounting
The maximum extension of the latch is 14 mm (0.55 in.) in the open position. A
flat-blade screwdriver is required for removal of the controller. The controller can
be mounted to EN50022-35x7.5 or EN50022-35x15 DIN rails. DIN rail
mounting dimensions are shown below.
Dimension
A
B
C
To install your controller on the DIN rail:
1. Mount your DIN rail. (Make sure that the placement of the controller on the
DIN rail meets the recommended spacing requirements, see Controller
Spacing on page 9. Refer to the mounting template inside the back cover of
this document.)
2. Close the DIN latch, if it is open.
3. Hook the top slot over the DIN rail.
4. While pressing the controller down against the top of the rail, snap the bottom
of the controller into position.
5. Leave the protective debris strip attached until you are finished wiring the
controller and any other devices.
1762-IN006A-ML-P
Height
90 mm (3.5 in.)
27.5 mm (1.08 in.)
27.5 mm (1.08 in.)
B
A
C