Iomega ditto Manual Del Usuario página 5

Using this section as a guide, you will be able to install your
new internal tape drive. Installation of the tape drive
requires three basic steps.*
1 Preparing your computer
2 Preparing the drive
3 Connecting the drive to the computer
These steps are explained in an on-line video on the Ditto
Tools CD. Before you turn your computer off, we
recommend you view this video.
To complete this project you will need a phillips screw-driver
and, perhaps, a flathead screwdriver. We also recommend
that you set your computer on a table (not the floor) to
install the drive.
*If you are installing a Ditto Dash accelerator card, see the Ditto Dash Installation Guide, and
install the card before installing the drive.
Getting Started Getting Started
Getting Started Getting Started Getting Started
Unpack the tape drive and accessories onto a table.
Caution: Touch a grounded metal object (like a metal cover screw on your computer) to
discharge personal static electricity before handling the tape drive.
Mounting Screws
Tape Cable
Tape Drive
Iomega Backup Software
5