Operating Characteristics - Kidde KN-COPP-B-LS Guia Del Usuario

5. Model KN-COB-B-LS Operating Characteristics
Whenever the alarm is operating, the green Power LED flashes every 30
seconds to indicate the unit is monitoring for CO. If the alarm senses
dangerous levels of CO, the red Alarm LED will flash and the alarm will
emit an audible alarm pattern.
Operating and Alarm Characteristics
Function LED Display Alarm Sound
Normal Green LED None
Operation flashes every 30
seconds
Carbon Red LED flashes 4 quick beeps,
monoxide with beeps. 5 seconds
alarm silence,
repeating
Low Red LED flashes One quick
battery every 30 seconds beep every
30 seconds
Error / Red LED flashes One quick
service every 30 seconds beep every
alarm 30 seconds
Error Red LED Constant
constantly on alarm
Normal Red LED flashes 4 quick beeps,
Test/Reset with beeps. 5 seconds
function Green and amber silence,
LED's on repeated once
End of Red LED flashes One quick
unit life every 30 seconds beep every 30
indicator seconds
6. Model KN-COPP-B-LS (with digital display)

Operating Characteristics

When the unit is first powered up, the green Operate LED flashes once
every 30 seconds and the digital display will show three "eights" – indi-
cating the alarm is in the start-up mode. The three "eights" will remain
for approximately 30 seconds. Then, the alarm will display "0" and
begin monitoring the air for CO and will continue to do so as long as it
receives power.
This alarm will display a "0" if CO concentrations between 0 and 30
PPM have been detected within the last 15 seconds.
Unit Status Recommendation
Normal DC None
operation (sensing
no CO) and with
good batteries
Alarm condition. Refer to "What to do
Dangerous When the Alarm
concentrations of Sounds" (inside front
CO detected cover)
Batteries need to be Replace all three AA
replaced batteries
Unit is in error Replace battery.
condition If condition continues,
unit has malfunc-
tioned. Replace
Very low battery or immediately. Unit will
not respond to CO
unit malfunction
Normal operation CO not detected.
when Test/Reset Alarm for test
button is pressed purposes only
End of unit life Replace unit immedi-
ately. Unit will not
respond to to CO
6. Model KN-COPP-B-LS (with digital display)
Operating Characteristics
The following table illustrates the possible digital displays, describes the
audible alarm patterns, and the recommended actions to take.
Operating and Alarm Characteristics
LCD Display Shows Alarm Sound
A steady display of 4 quick beeps,
CO concentration 5 secs. silence,
from 30-999. Red repeating for 4
LED flashes with beep min.– then 4
quick beeps
every minute
Brief "888" for None
approximately 30
seconds
A random number 4 quick beeps,
is displayed – 5 seconds
approximately 200 silence,
repeated once
Steady "0" None
displayed, dot flash-
ing every 5 seconds,
Green LED flashes every 30 secs.
"Lb" flashes alter- One quick beep
nately with any every 30 seconds
number, Red LED
flashes every 30 seconds.
"Err" displayed One quick beep
every 30 seconds
Display is blank Constant alarm
Number from 11- None
999 displayed.
"End" displayed. One quick beep
Red LED flashes every 30 seconds
every 30 seconds
The problems listed above are under normal operating conditions. Other
"Err" conditions could exist. If you should have any questions regarding
display conditions, call our Consumer Hotline.
Unit Status Recommendation
Alarm condition. Refer to "What to do
Dangerous When the Alarm
concentrations of Sounds" (inside front
CO detected cover)
Self test when first None – CO has not
powered up been detected.
Numbers shown for
test purpose only
Test/Reset button is None – CO has not
pressed been detected.
Numbers shown for
test purpose only
Normal DC None
operation with
good batteries
(sensing no CO)
Batteries need to Replace all three AA
be replaced batteries immediately
Unit is Error condi- Replace batteries.
tion If "Err" (or blank
display) continues,
unit has malfunc-
tioned. Replace
immediately. Unit will
Unit malfunction
not respond CO
Peak Level Memory Refer to following
activated. Highest section for informa-
concentration of tion regarding Peak
CO detected is dis- Level Memory
played
End of unit life Replace unit immedi-
ately. Unit will not
respond to CO.