Tabla de contenido
3.7. Loosening
• Hold the buckle fi rmly with one hand, and pull the strap up-
ward with the other hand.
Buckle
3.8. Inverting the lever operating side
This sprayer is shipped assembled for installing the pumping
lever for left hand operation. In case you wish to invert to right
hand operation, proceed as follows:
• Remove the locking ring (1), washers and rod (2) from the
compensation chamber.
• Next, rotate the compensation chamber a 180º turn.
• Reinstall the rod (2) on the chamber and secure it with the
cotter pin again.
• Remove locking rings (4), cotter pin (5) and washers.
• Remove the pumping lever (6).
• Remove the shaft (7) and detach the shoulder straps (8) from
both sides.
• Invert the positions as shown in the fi gure below (To install
the shaft, follows instructions of the item 05). Install the
washers and pumping lever on the rod so as to be operated
with the right hand.
Locking ring (1)
Rod (2)
(5)
(7)
(4)
(6)
B
(8)
Correct volume of water
• Invert the shoulder straps position as shown below.
3.9. Storage
The sprayer should be stored in secure and ventilated place. Do
not store equipment with mixture in the tank. The chemicals can
cause diff erent reactions and damage components of the equip-
ment and the health of the operator.
CAUTION!
TRANSPORTATION: The sprayers can not be
carried along with food, beverages, pharma-
ceuticals, feed, animals and people without
adequate equipment (PPE).
4. Operation of Product
4.1. Recommendations for use
This equipment must be used only with products to protect
plants approved for backpack sprayers. After assembling the
sprayer, fi ll the tank with water and check for any leaks. Any leak
must be repaired before using the sprayer.
Do not use acids or fl ammable liquids. After use of herbicides
clean the equipment before using other formulations.
4.1a. Best spraying practices
Correct proportion of product
5/35
Capítulos
Tabla de contenido
