Installing The Shaft; Installing The Lever On The Shaft And The Rod On The Chamber Top; Attaching The Lance To The Trigger Valve (Starting And Stopping); Adjusting The Strap - Jacto CD Serie Manual Del Operador

3.2. Installing the shaft

• Install the shaft (1) into the free hole on the sprayer base
(chamber side).
• Use a plastic hammer to tap the shaft smoothly until the hole
on the shaft end matches the hole on the base reinforcement.
• Lock the shaft with the cotter pin (2).
2
1
Hammer
3.3. Installing the lever on the shaft and the
rod on the chamber top
• Lightly grease the lever orifi ce and instal it on the rod. Install a
fl at washer before the locked ring.
• Lightly grease the orifi ce on the chamber top.
• Install a fl at washer on the shaft and rod.
• For ease of assembly, install the lever on the shaft and the rod
on the chamber top at the same time.
• Install the other fl at washers on the shaft and rod and lock
with the locking ring.
Rod
Lever
locking ring
4/35
Base
reinforcement
locking ring
Shaft
Washers
3.4. Attaching the lance to the trigger valve
(starting and stopping)
• Push the lance into the trigger valve and secure it with the
screw cap.
• Unscrew the trigger valve nut.
• Push the hose through the nut and connect to the trigger
valve body.
Elbow
Lance
Trigger
valve
WARNING!
Do not overtighten the screw cap.

3.5. Adjusting the strap

• The tank is contoured for the operator comfort. The shoulder
straps can be quickly adjusted to properly position the spray-
er on the operator's back.

3.6. Tightening

• Hold the strap buckle fi rmly with one hand, and pull the han-
dle downward with the other hand.
Handle
Trigger valve
Lock
Hose
A
Buckle