Tabla de contenido
4.7. Disposal of waste products
The elimination of waste resulting from the dismantling of
equipment during service, maintenance or end of life (disposal)
should be carried out respecting the environment, preventing
pollution of air, soil and water. If necessary, the waste should be
stored in appropriate locations and then transported by quali-
fi ed and trained people and companies.
Disposal of used sprayer should be done at appropriate areas
and approved for receiving such material. If there isn't an appro-
priate nearby site, please contact the Customer assistance: JAC-
TO INC. 19217 SW 119th Ave - Tualatin, Oregon 97062. Phone:
(503) 885-8723, Fax: (800) 511-3671, Toll free: (800) 522-8610 -
E-mail: [email protected] - Home page: www.jacto.com.
5. Information Needed by User
5.1. Troubleshooting
• Put about 1/2 gallon of water in the tank.
• While operating the lever, look into the tank to see what
problem arises.
• Refer to the table and diagram below.
DESCRIPTION
Leakage through the cylinder upper part.
After pumping and
pressurizing the chamber, as you operate
the lever it drops fast.
After pumping and
pressurizing the chamber, the lever rises
quickly when released.
12/35
CAUSES
Worn or dried out
piston cup.
Cylinder valve
not sealing properly
due to wear or impurities.
Chamber valve
not sealing properly
due to wear or impurities.
CORRECTIONS
Replace or lubricate
the pump.
Clean or replace
the valve.
Clean or replace
the valve.
Capítulos
Tabla de contenido
