American Standard Town Square S 3851A Instrucciones De Instalación Cuidado Y Mantenimiento

INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
Town Square
®
1.28 gpf / 4.8 Lpf 2-piece Toilet
3851A
Model - Elongated, Right Height
Thank you for selecting American Standard - the benchmark of fine quality for over 140 years. To ensure this product is
installed properly, please read these instructions carefully before you begin. (Certain installations may require
professional help.) Also be sure your installation conforms to local codes.
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
!
NOTE: Pictures may not exactly define contour of china and components.
RECOMMENDED TOOLS AND MATERIALS
Putty Knife Regular Screwdriver
Hacksaw Wax Ring/Gasket
1 REMOVE OLD TOILET
a. Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.
b. Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply!
c. Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.
d. Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE: Mounting surface must be clean and level before new toilet is installed!
2
ROUGHING-IN DIMENSIONS:
NOTE: Distance from wall to closet flange centerline must be as listed below:
8-1/8"
(207mm)
3-3/8"
(87mm)
8-1/2"
(217mm)
12"
(305mm)
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2019
S
Adjustable Wrench
Flexible Supply Tube
30-1/4"
(768mm)
18-7/8"
(480mm)
18-1/2"
(470mm)
SUPPLY
AS
REQUIRED
(position 1 or
position 2)
16-1/2"
(419mm)
5-1/2"
(140mm)
14-5/8"
(373mm)
FINISHED
FLOOR
with Seat
®
Sealant
Closet Bolts
16-5/8"
(722mm)
14"
(356mm)
14-3/4"
(376mm)
31-1/8"
(791mm)
2-1/4"
2-1/4"
8" (57mm)
(57mm)
(204mm)
6"
(152mm)
12-3/4"
(326mm)
Tape Measure
Carpenters Level
IMPORTANT: Water supply on
the wall is required at 2-1/4" or
8" from centerline of the toilet
(see rough-in). First suggested
position is hidden behind the
toilet. The geometry of the toilet
gives space for this installation.
The second suggested position
is next to the toilet. Between
these two positions, the space
for the supply between wall and
toilet is limited to 3-1/2". In this
case, check your supply and
hose dimensions.
7 30 2 42 7- 10 0 ( 3 /19 )