Kenwood KOS-A200 Manual De Instrucciones página 31

SIRIUS source
?
No broadcast can be received.
✔ The Sirius antenna in not connected.
☞ Connect the wire correctly.
✔ No subscription is established.
☞ Subscribe to SIRIUS.
HD Radio source
?
No sound can be heard, or the volume is low.
✔ The preset broadcast station is not transmitting
in the mode that was set with <Receive mode
Setting>.
☞ Please set <Receive mode Setting> (page 24)
to "AUTO".
✔ In digital AM broadcasting, receive mode switches
between stereo and monaural too often.
☞ Receiving condition is bad or unstable.
Stereo is chosen when receiving condition is
good, and it switches to monaural when the
condition becomes bad.
✔ HD Radio tuner is connected to KCA-S210A or
other units.
☞ Connect the HD Radio tuner directly to the
control unit.
USB device source
?
The USB device is not detected.
✔ The USB connector is disconnected.
☞ Connect the connector of the USB device
properly.
?
The USB device does not play its audio files.
✔ The USB connector is disconnected.
☞ Connect the connector of the USB device
properly.
The messages shown below display your
systems condition.
EJECT: No disc magazine has been loaded in
the changer. The disc magazine is not
completely loaded.
➪ Load the disc magazine properly.
No CD in the unit.
➪ Insert the CD.
NO DISC: No disc has been loaded in the disc
magazine.
➪ Load a disc into the disc magazine.
TOC ERR: No disc has been loaded in the disc
magazine.
➪ Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-
down. The CD is scratched a lot.
➪ Clean the CD and load it correctly.
READ ERR: • The number of files or folders which are
stored in the connected USB device is
above the limitation.
• The file system of the connected USB
device is broken.
➪ Copy the files and folders for the
USB device again referring to www.
kenwood.com/usb/. If the error
message is still displayed, initialize the
USB device or use other USB devices.
E-05: The CD is upside-down.
➪ Load the CD correctly.
BLANK: Nothing has been recorded on the MD.
NO TRACK: No tracks are recorded on the MD,
although it has a title.
NO PANEL: The faceplate of the slave unit being
connected to this unit has been removed.
➪ Replace it.
E-77: The unit is malfunctioning for some reason.
➪ Reset the unit. If the "E-77" code does
not disappear, consult your nearest
service center.
E-99: Something is wrong with the disc
magazine. Or the unit is malfunctioning for
some reason.
➪ Check the disc magazine. And then
reset the unit. If the "E-99" code does
not disappear, consult your nearest
service center.
LOAD: Discs are being exchanged in the Disc
changer.
31
|
English