Installing For Group 1 (9-18Kg) - Foppapedretti CAR&GO Manual Del Usuario

Release catch (A) on the top left hand side of the shell and remove the installation
bar (B). Tilt the seat shell forwards, feed the seatbelt between the seat and the
base and plug the buckle in ensuring the seatbelt is not twisted.
Push the child car seat back into the passenger seat ensuring a good fit.
D
D
E
E
CAR&GO
installing for group
Place the child car seat on a suitable
passenger seat.
Pull the recline adjuster handle under the
front of the shell and adjust the shell to its fully
reclined position.
C
C
F
F
1 (9-18
Thread the horizontal lap belt section
under both hooks (C) and remove all the
slack by pulling up on the diagonal section
of seatbelt. Thread the diagonal section
through the lock off device (D) that is
nearest to the seatbelt.
To operate the lock-off device: Pull down
on tab (E) to open the locking device. Lift
up the latch (F). Pass the seatbelt under
the latch and pull the belt tight (G). Close
the latch and fasten the tab (H) whilst
holding the diagonal section of seatbelt
tight.
G
G
)
kg
B
B
H
H
33