Festo DSMI Serie Instrucciones De Utilizacion página 28

DSMI-...
8. Adjust the stops of the end positions statically depending on the type.
– Stop type without integrated shock absorber in the connection.
– In the case of the stop type with shock absorber in accordance with
"Accessories" on page 30:
9. Use preferably symmetrical angle posi-
tions related to the symmetry line of the
DSMI-... .
These result in a more even movement
between the left and right-hand swivels.
Static pre-adjustment of a stop
Warning
The DSMI-... will be damaged if it is operated without stops.
S Always leave the stop fitted to the DSMI-... .
In order to shift the stops, you simply need to loosen the locking screws a
little, so that it is just possible to shift the stops.
S Make sure that the locking screws are then tightened again with the specified
tightening torque.
Static pre-adjustment of a stop without a shock absorber
1. Pull the protective cap off the housing of
the DSMI-... .
2. Swivel the moveable mass into the
desired end position.
This can be accomplished with a non-press-
surized DSMI-... either by hand or with a
hexagon socket wrench. The degree scale
can be used for accurate positioning.
Nominal size
Degree graduation (1 graduation mark =)
28
M
I
Fig. 13
Fig. 14
M
Fig. 15
DSMI-25 DSMI-40
2° 1°
Festo DSMI-... 0102NH English
I
I