Craftsman 580.752381 Instrucciones De Uso página 10

HOWTO USEYOUR PRESSURE WASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at 1-800-222-3136.
Pressure Washer Location
PressureWasherClearance
_i, WARNING Exhaust heat/gases can ignite
combustibles, structures or damagefuel tank
causing a fire.
• Keepat least 5 ft. (152 cm) clearanceon all sides of pressure
washer including overhead.
Place pressure washer outdoors in an area that will not
accumulate deadly exhaust gas. DO NOT place pressure
washer where exhaust gas (A) could accumulate and enter
inside or be drawn into a potentially occupied building.
Ensure exhaust gas is kept away from any windows, doors,
ventilation intakes, or other openings that can allow exhaust
gas to collect in a confined area. Prevailing winds and air
currents should be taken into consideration when positioning
_ressure washer.
_i, WARNING Running engine gives off carbon
monoxide, an odorless, colorless, poisonous gas.
_ Breathing can cause headache,
carbon monoxide
fatigue, dizziness,vomiting, confusion, seizures,
nausea, fainting or death.
• Operate pressure washerONLYoutdoors.
• Keepexhaust g asfrom enteringa confined areathrough
windows,doors,ventilationintakes, o r otheropenings.
• DONOT startor run engineindoorsor in an enclosed area,
evenif windowsanddoorsareopen.
To Start Your Pressure Washer
To start your engine-powered pressure washer for the first
time, follow these instructions step-by-step. This starting
information also applies whenever you start the engine after you have let the pressure washer sit idle for at least a day.
1. Placepressure washer near an outside water source
capableof supplying water at a flow rategreaterthan
5.0 gallons per minute and no less than 20 PSIat pressure
washer end of garden hose.
2. Check that high pressure hose is tightly connected to
spray gun and pump. See Assemblyfor illustrations.
3. Make sure unit is in a level position.
4. Connect garden hose to water inlet on pressure washer
pump.
NOtiCE DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment r esultingfrom failureto follow this
instruction will voidwarranty.
.
.
Turn ON the water, press red button on the gun and
squeezethe trigger to purge the pump system of air and
impurities.
Attach nozzle extension to spray gun. Tighten by hand.
7. Choose spray tip you want to use, pull back on collar of
nozzle extension, insert spray tip and releasecollar. Tug
on spray tip to make sure it is securely in place. See
How to Use Spray Tips.
8. Move fuel valve lever (B) to "On" position.
(_ OFF
10