For Best Results - Cooper Lighting MSLED Manual De Instrucciones

MSLED 825-0504.qxd:Layout 1
• Charge the battery provided with or identified for use with this product only in
accordance with the instructions and limitations specified in this manual.
• Observe proper polarity orientation between the batteries and battery
charger/compartment.
• Disassembly of your fixture will void the warranty.
• Do not cut the solar panel wire. Discontinue use if the wire becomes frayed or broken.
SAVE THESE INSTRUCTIONS

FOR BEST RESULTS

• Locate solar panel in an area that will receive the maximum amount of sunlight
during the daylight hours.
• Allow fixture to receive two full days of sunlight before turning fixture ON.
• Install your fixture 8-12 feet above ground (motion detector is less sensitive
above 12 feet).
• Locate fixture so motion moves across detection zone (Fig. 1).
• Locate fixture away from heat producing sources to prevent
false triggering. Also be very careful not to include objects
such as windows, white walls and water in the detection
zone whenever possible.
• Locate fixture away from moving objects such as trees and
street traffic.
• You will need to adjust the angle of the solar panel throughout the year
as seasons change in order to keep it at the best possible angle to the sun.
• Keep solar panel clear of any objects that will block the sunlight. It will be
necessary to periodically clean the solar panel with soft wet cloth.
• During periods of several cloudy days, the battery will become discharged and
will need to be recharged with sunlight.
• After receiving full charge, fixture ON capacity is approximately 3 hours.
HOW TO REPLACE BATTERIES
Note: Use only the following type and size battery: "AA" Ni-MH rechargeable
batteries. Make sure that replacement batteries are the same dimension and
capacity as the current batteries.
• When replacing the batteries the switch on the main unit must be in the OFF position.
• Turn the fixture to the OFF position and unplug the solar
panel from the cable leading to the fixture. Remove
fixture from it's mounting surface by removing the two
screws on each side of the fixture. Remove the 4
screws on the back (Fig. 2). Pull out the battery tray
and remove the old batteries by hand. Insert new
batteries and reinsert battery tray. Be sure that wiring
has not been pinched. Replace battery cover with the
4 screws provided. Allow fixture to receive three full
days of sunlight before turning fixture ON.
For assistance, call 1-800-334-6871 or e-mail us at [email protected]
1/19/10 9:29 AM Page 3
3
Fig. 1
Fig. 2