Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Fig. 4 Finish plumbing, wiring and switch locations
Pump power
and switch cord
grommet.
Pump switch.
Radon Installation
IMPORTANT: All installations in Radon environments should be done by a qualified professional and in accordance with
applicable codes.
A.
The access cover must seat against the secure cover to ensure the gaskets provide a sealed gas-tight system (see fig. 5).
Additionally, ensure that the gaskets between the covers create a seal.
B.
Install a 3" vent line at the cover connection labeled "OPTIONAL RADON VENT LOCATION". Use a 4" hole saw to create a hole
in this location. A dimple is provided on the cover to properly center the drill (see figure 4, above). Install the provided 3" pipe seal
in the hole. Place 3" PVC vent pipe from the vent system through the pipe seal. Do not place the vent pipe more than 4" into the
basin.
Fig. 5 Correct Access Cover Installation
There should be
no gap between
covers for the best
possible seal.
©Copyright 2012 Liberty Pumps Inc. All rights reserved
Optional radon vent location (see
Radon Installation section). Use a 4"
1-1/2" threaded
hole saw to open the hole. The dimple
discharge location.
serves as a center mark for drilling.
Optional alarm
switch cord
grommet.
Optional alarm
switch.
Secure Cover
Gasket tape should
contact access
cover in this area
Access Cover
5
Tabla de contenido
