Tabla de contenido
Idiomas disponibles
Idiomas disponibles
03P-0006/HDB24EA manual
Checking water temperature
• The minimum incoming temperature must be at 120˚F/49˚C in order for
the detergent to dissolve properly.
If you are unsure of the temperature of your hot water:
1. Open the hot water faucet and let it run for a minute and fill a glass.
2. Take a thermometer and check the temperature of the water.
3. If the temperature is below the recommended 120˚F / 49˚C, then you
need to adjust the water temperature on your water heater in order to
maintain that temperature level.
Overflowing protection
• In case the water level is rising above the highest acceptable point, the
security pressure switch will activate the drain pump automatically.
Cycle selection chart
Turn the cycle control knob to the desired cycle. If the door is properly
closed the cycle will start.
Turn the cycle knob to rinse and hold to use this feature. DO NOT activate
the heated dry option while using this feature. Do not use detergent in this
cycle.
Pre-wash
pots & pans
heavy wash
normal
wash
rinse & hold
* Small amounts of water run through the pump to remove soil particles.
• Shows what steps are there in each cycle. Cycle time includes dry time. Cycle
time may be longer depending on the temperature of the water entering the
dishwasher.
Note: Cooler the water, longer the cycle time.
11/7/03
5:42 PM
Page 14
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
English
12
Tabla de contenido
