Glem GFLP Manual De Uso página 18

3172618-001 ItIFPE.qxd:-
INCIDENTS WHEN OPERATING THE PYROLYTIC FUNCTION
INCIDENT
My accessories and shelf
supports are damaged.
The enamel colour has
changed and stains have appe-
ared.
The oven door is locked, pilot
light is lit up but the oven is
not hot.
I have turned the control dial to
position , pressed the
key, I can see the P1, P2 or P3
on the display but the pilot light
is not lit up and the oven is
not heating up.
I have turned the control dial to
position , pressed the
key, I can see the P1, P2 or P3
on the display but the pilot light
is not lit up and the oven is
not heating up.
I have programmed the
pyrolysis function, the oven is
working properly but pilot light
is not lit up.
The pyrolysis programme has
ended and the oven is cold, but
the door is locked and symbol
is flashing.
18
30/1/13 12:50 Página 18
CAUSE
You have not removed the acces-
sories and supports during the
pyrolytic cleaning cycle.
The chemical composition of
some foodstuffs may cause
changes in the enamel.
You have turned the control
dial to position
other additional operation has
been performed.
The oven door is not closed
properly, so the door cannot be
PIRO
locked.
The door switch is not working
even though the door is
PIRO
properly closed.
Pilot light does not work pro-
perly.
You did not turn the control dial
to position when the pyroly-
sis programme ended.
You must replace them and
remove them in later cleaning
cycles.
This is normal and does not
damage the properties of the
enamel.
Switch off the oven and follow
and no the instructions to unlock the
door in the first 30 minutes at a
low temperature.
Next, select the pyrolytic
function, carefully following the
instructions.
Check the door and make sure
that it is closed properly.
Call Technical Assistance
Service as there is a fault in
the door switch.
Call the Technical Assistance
Service.
1. Turn the control dial to
position
minute.
2. Turn the control dial to posi-
tion
te.
3. Turn the control dial to posi-
tion again and wait until
pilot light
4. Press the
seconds.
SOLUTION
and wait for 1
and wait for 1 minu-
turns off.
key for 3
PIRO