Glem GFLP Manual De Uso página 16

3172618-001 ItIFPE.qxd:-
PROGRAMMING AND OPERATING THE PYROLYTIC FUNCTION
Follow the instructions below to carry out a
pyrolytic cleaning cycle:
1 IMPORTANT: Remove all accessories
(shelves, grids, side supports to hold up
the shelves, telescopic guide rails) from
inside the oven.
2 Turn the cooking control dial to Pyrolysis
position .
3 Next, press the
should appear on the timer display.
4 After a few seconds, P2 (pyrolysis program-
me 2) will appear on the timer display, the
BACK symbol will also remain lit up.
5 You can now change the pyrolysis program-
me to P1, P2 or P3 by pressing the + or –
keys:
P1: Minimum programme. Duration 1 hour
P2: Standard programme. Duration 1 hour
and 30 minutes
P3: Maximum programme. Duration 2 hours
6 You will hear 2 consecutive beeps after seve-
ral seconds or by pressing the
firming the chosen programme.
7 You can still change the pyrolysis program-
me by pressing the
keys.
8 After a short time, you will see the time
remaining for the selected programme to
end and the symbols
on the timer display. The pilot light
turn on and the oven door cannot be ope-
ned, as the heating will have begun.
IMPORTANT: At this point, the oven is program-
med and the pyrolytic cleaning cycle is under-
way. During the cycle, none of the timer func-
tions can be selected, except the child lock. Do
not try to open the oven door as it may interrupt
the cleaning process.
16
30/1/13 12:50
key, the word PIRO
PIRO
key con-
PIRO
key and the + or –
PIRO
and BACK lit up
will
Página 16
9 When the pyrolytic cleaning cycle has finis-
hed, an alarm will sound, the symbol
will flash and you will see the correct time on
the display.
10 Press any of the timer's keys to disable the
alarm.
11 Set the cooking control dial to position
12 The oven's heating process has ended,
however the oven is extremely hot and can-
not be used. The cooling motor will operate
until the oven cools down, pilot light
will remain on and the symbol
on the timer display.
IMPORTANT
The cooling process may last up to 2 hours owing
to the high temperatures inside the oven.
13 Once the oven has cooled down, pilot light
will automatically turn off.
14 Press the
PIRO
hing. .
IMPORTANT
To open the door (pilot light
must be in position
truction 11 set the control dial to position
wait a few minutes until the door unlocks and the
pilot light switches off.
15 Open the oven door and wipe the inside with
a damp cloth, cleaning up the ash from the
cleaning cycle. Areas in the oven that are dif-
ficult to access will need to be cleaned with
a non-metallic fibre scourer.
16 Once the oven is clean, do not forget to
replace the supports and accessories.
17 The oven is now ready to be used.
IMPORTANT: If any incidents are detected in
the programming and operating of this func-
tion, consult the section "Incidents while
Operating the Pyrolytic Function".
.
will flash
key to stop symbol 9 flas-
on), the control dial
. If you did not follow ins-
and