Tabla de contenido
Idiomas disponibles
Idiomas disponibles
HOWTO USEYOUR CLEANIHG SYSTEM
If you haveany problems operating your pressure washer,
please call the pressure washer helpline at 1-800-222-3136.
Pressure Washer Location
Pressure WasherClearance
_
Exhaustheat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
o Keep at least 5 ft. (152 cm) clearance on all sides of pressure
washerincludingoverhead.
Placepressure washer outdoors in an area that will not
accumulate deadly exhaust gas. DO NOT place pressure
washer where exhaust gas could accumulate and enter inside
or be drawn into a potentially occupied building. Ensure
exhaust gas is kept away from any windows, doors,
ventilation intakes, or other openings that can allow exhaust
gas to collect in a confined area. Prevailingwinds and air
currents should be taken into consideration when positioning
_ressurewasher.
WARNING
Running engine gives off carbon monoxide, an
odorless, colorless, poison gas.
_
reathing carbon monoxide can cause headache,
fatigue, dizziness, vomiting, confusion, seizures,
nausea, fainting or death.
o Operate pressure washerONLYoutdoors.
o Keepexhaustgasfrom enteringa confinedareathrough
windows,doors,ventilationintakes,or otheropenings.
o DONOTstartor run engineindoorsor in an enclosed area,
evenif windowsanddoorsare open.
To Start Your Cleaning System
To start your engine-powered cleaning system for the first
time, follow these instructions step-by-step. This information
also applies whenever you start the engine after you have let
the pressure washer sit idle for at leasta day.
1.
Placepressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.3 gallons per minute and no less than 20 PSI at
pressure washer end of garden hose.
2.
Checkthat high pressure hose is tightly connected to
spray gun and pump. See "Assembling Your Pressure
Washer" for illustrations.
3.
Make sure unit is in a level position.
4.
Connectgarden hose to water inlet on pressure washer
pump.
5.
Turn ONwater, point gun in a safe direction and squeeze
trigger to purge pump system of air and impurities.
I DO NOT run the pump without the water supply connected
land turned on.
I ° Damage to equipment r esultingfrom failureto follow this
instructionwill voidwarranty.
6.
Attach nozzleextension to spray gun. Tighten by hand.
Choose ProjectPro
TM
nozzleyou want to use, pull back
on collar of nozzle extension, insert nozzle and release
collar. Tug on nozzle to make sure it is securely in place.
See "How to Use ProjectPro
TM
NozzleSystem".
8.
Engagetrigger lock to spray gun trigger.
Trigger Lock
Tabla de contenido
