Aqua Medic aquareefLED Manual Del Usuario página 6

LED aquarium lighting for salt and fresh water aquaria
The housing is made of powder-coated and saltwater resistant aluminium.
1. Technical Data
Line voltage: 230 Volt/50 Hz (if not stated otherwise on the ID-label).
- total lumen 3.558
- colour temperature 14,000 K
- 11 white LED's, 7 blue LED'S (total 50 watt)
- safety tension 24 V with external power pack
Dimensions:
27 x 36.8 x 2.4 cm (l x w x h)
2. Unpacking
On unpacking, please check the lighting system immediately for any damages. In case of any
complaints, please contact your dealer directly.
Included in shipment:
aquareefLED
•
steel wire suspension aquafit II
•
3. Safety advices
The lighting system cannot be used as aquarium cover. It has to be mounted only above the
•
aquarium. The minimum distance between lighting and aquarium must be at least 30 cm.
The housing may become hot during operation. Be cautious when touching it!
•
For cleaning, disconnect the lighting system from the mains and let it cool down. Afterwards,
•
take the lighting down.
When cleaning and during operation, take care that no humidity enters the interior of the
•
lighting system!
Pay attention to a sufficient thermal exchange. Do not mount the system in enclosures or
•
behind panels. Missing aeration may result in overheating and damage the electric components.
Do not try to repair the lighting system (LED's, electronic parts). Please send it in for checking,
•
preferably with a list of defects. Even broken LED's can only be changed by the manufacturer.
When working on the light, always pull all power plugs.
•
4. Installation
The light can be fixed at the ceiling with the attached steel wire suspension.
Contents:
The suspension system comprises 2 pcs. of each of the following:
1. Ceiling plate with screws and plugs, 2 metre stainless steel wire with stopper
2. Light fixing (wire with Y-piece and end bushes)
Mounting:
The two ceiling plugs (1.1) must be securely screwed to the ceiling by using the screws and plugs.
6