Installing "AA" type rechargeable batteries
To use "AA" type batteries, please purchase an accessory "Yukon DNV Battery
Holder" (SKU#29116).
WARNING! Please use only rechargeable type "AA" (LR06) batteries.
The use of regular (non-rechargeable) batteries drastically reduces rifle-
scope's operating time.
•
Turn the knob of the battery compartment cover (7) 90° counterclockwise to
the Open position and remove the battery container by raising it by its lug.
•
Slide in four АА batteries so that the "+" and "-" match the polarity on the
compartment.
•
Insert the battery compartment into its place and turn the knob 90°
clockwise (see section "External View and Components").
Warning!
To prevent short circuit, do not carry the battery Pack outside its pouch in a
pocket, especially together with metal objects.
Operation
9
Installation of mount
Before using the riflescope you need to install a mount (12) (Pic. 4) (may not be
included).
The mounting holes in the base of the riflescope enable the mount to be
installed in one of the multiple positions. The choice of the mounting position
helps the user to ensure the correct eye relief depending on the rifle type.
•
Attach the mount to the base of the riflescope using a hex-nut wrench and
screws.
•
Install the riflescope on the rifle and check if the position is suitable for you.
•
If you are happy with its position, remove the riflescope, unscrew the screws
halfway, apply some thread sealant onto the thread of the screws and
tighten them fully (suggested torque power is 2-3Nm). Let the sealant dry for
a while.
•
The riflescope is ready to be installed on a rifle and to be zeroed.
•
After first installation of your riflescope on a rifle, please follow instructions
in the section "Zeroing".
Powering on and image setup
•
Open the lens cover (2).
•
Turn the riflescope on with a short press of the ON (4) button. Image appears
on the display in several seconds.
•
To turn off the display during operation, press and hold down the ON button
longer than one second.
•
Turned off display will show a message "Display off".
•
To turn on the display, press briefly the ON button.
•
To turn off the riflescope, press and hold down the ON button longer than
three seconds. Display will show a message "Display off" and a countdown
from 3 to 1 sec, and will turn off upon countdown expiration.
8