Start Up; Electrical Connection; Water Connection; Operation - Kärcher HD 10/25 S Manual De Instrucciones

Start up

Electrical connection

Warning
The appliance may only be connected to al-
ternating current.
The appliance may only be connected to an
electrical supply which has been installed in
accordance with IEC 60364.
The voltage indicated on the type plate
must correspond to the voltage of the elec-
trical source.
The minimum fuse rating required at the
socket outlet is (see technical specifica-
tions).
The maximum tolerable mains impedance
at the electrical contact point (see Techni-
cal Data) must not be exceeded.
The appliance should always be connected
to the electrical mains using a plug. It is for-
bidden to permanently connect the appli-
ance to the power supply. The plug is only
for mains separation.
Check the power cord with mains plug for
damage before every use. If the power cord
is damaged, please arrange immediately
for the exchange by an authorized custom-
er service or a skilled electrician.
The plug and coupling of the extension ca-
ble used must be watertight.
Use the extension cord that has an ade-
quate cross-section (see "Technical Data")
and unwind it fully from the cable drum.
Unsuitable extension cables can be haz-
ardous. Only use extension cables out-
doors which have been approved for this
purpose and labelled with a sufficient cable
cross section:
For connection values, see type plate/tech-
nical data.
16
English

Water connection

Connection to the water supply
Warning
Observe regulations of water supplier.
According to the applicable regulations, the
appliance must never be used on the drink-
ing water net without a system separator.
Use a suitable system separator manufac-
tured by Kärcher; or, as an alternative, a
system separator as per EN 12729 Type
BA.
For connection values refer to technical
specifications
Connect the supply hose(minimu length
7.5 m, minimum diameter 3/4") to the
water connection point of the machine
and at the water supply point (for e.g. a
tap).
Note
The supply hose is not included.
Open the water supply.
Drawing in water from open reservoirs
Screw the suction hose with filter (order
no. 4.440-238.0) to the water connec-
tion.
Deaerate the appliance:
Unscrew the nozzle.
Switch on the appliance and let it run
until the water exiting is bubble-free.
Switch off the appliance and fit the noz-
zle again.

Operation

Danger
If the appliance is used in hazardous areas
(e.g. filling stations) the corresponding
safety provisions must be observed.
Warning
Clean engines only at places with corre-
sponding oil separators (environmental
safety).
Wash animals only with a flat low pressure
jet (see "Select spray type").