Important Notice; Starting Recommendations - golmar T22ML Manual De Instalación

INTRODUCTION
First of all we would like to thank and congratulate you for the purchase of this product
manufactured by Golmar.
The commitment to reach the satisfaction of our customers is stated through the ISO-9001
certification and for the manufacturing of products like this one.
Its advanced technology and exacting quality control will do that customers and users enjoy with the
legion of features this system offers. To obtain the maximum profit of these features and a properly wired
installation, we kindly recommend you to expend a few minutes of your time to read this manual.
SYSTEM CHARACTERISTICS
Audio system with 2 wires installation.
Surface panel installation, that avoids masonry works.
Just 1 TF-104 transformer (12Va.c., 1.5A).
Electronic call.
Automatic a.c. lock releases activation.
Telephone with call reception volume control and additional push button.

IMPORTANT NOTICE

This system must operate with automatic lock releases only, as the one supplied in the kit.
SYSTEM OPERATION
To make a call the visitor should press the push button corresponding to the apartment he wishes
to contact. An acoustic tone will be heard confirming the call as the push button is pressed. At
this moment the call will be received at the telephone in the dwelling.
To establish communication pick up the telephone handset.
To open the door, press the door release push button at any moment.

STARTING RECOMMENDATIONS

Do not use excessive force when tightening the transformer connector screws.
Install the equipment without the power connected. Disconnect from power before any system
modification. Check that the input voltage is lower than 230Va.c.
Before to connect the system, check the connections between door panel and telephones, and
the transformer connection. Do always follow the enclosed information.
13 14
I
nstalling the TF-104 transformer.
3,5 x 25
DIN-7971
The transformer can be installed on a DIN guide (3 units) simply pressing it.
To disassemble the transformer from the DIN guide, use a plain screwdriver to lever
the flange as shown on the picture.
R
emoving light socket and sound module.
The door panel fixing holes are accesible under the light socket and the sound module.
Insert and level a plain screwdriver to remove the light socket, as it is shown on the figure.
Remove the sound module from the fixing guides.
POWER SUPPLY INSTALLATION
The transformer must be installed in a dry and
protected place. It's recommended to protect
3,5 x 25
the transformer by using a thermo-magnetic
DIN-7971
circuit breaker.
To install the transformer directly on the wall,
insert the fixing flanges.
Drill two holes of Ø6 mm. and
insert the wallplugs.
Fix the transformer with the specified
DIN 46277
screws.
DOOR PANEL INSTALLATION