Kärcher CV 36/2 Manual De Instrucciones página 10

English
The brush and suction motor is switched off via the built-in
electronic system
Brush is blocked
- Withdraw mains plug, check brush for any dirt and if neces-
sary remove the blockage. The unit now has to be restarted.
Suction turbine switches off, brush head carries on
functioning (red indicator light goes off)
Thermal switch has disengaged motor due to overheating
- Withdraw mains plug, exchange blocked filter or eliminate
suction hose blockage. After approximately 20 minutes, the
unit will start up again.
Suction hose is blocked
Switch off the unit. Remove the flexible hose from the housing
and pull it straight. Use something long to release hose blocka-
ge.
- The suction hose can be disconnected from the unit by
pressing the locking lever. <Figure 11>
Connecting hose is blocked
- The connecting hose can be removed by pulling out both
ends. Remove the blockage. <Figure 12>
Brushes in brush head are not rotating, suction turbine is
running
Hand pipe is not pushed into motor housing properly, or end is
worn down
- If the end of the pipe has been worn down (due to vacuuming
without first fitting the crevice or upholstery nozzle), the end
switch will not be actuated and the brushes will not rotate.
Separating the brush head from the upper section of the
vacuum cleaner
• Undo the connecting cable, release the plug by pressing in
a pointed object (e.g. screwdriver). <Figure 13>
• The connecting hose can be removed by pulling out the two
ends.
• Undo both screws at the side of the upper section to the
vacuum cleaner.
10
6. In the event of malfunction
Figure 11
Figure 12
Figure 13