Tabla de contenido
Idiomas disponibles
Idiomas disponibles
sure tip of stop bolt (A) Fig.10 is against stop
plate (B). Then tighten lock handle (C).
Fig. 10
2. Using a square, check to see if the fence is at
90º to the table.
3. If the fence is not at 90º to the table, loosen
lock handle (C) and lock nut (D). Turn stop bolt
until its tip contacts the stop plate (B), tighten
lock handle (C).
4. Tilt the fence inward as far as possible and
using a combination square(45º), check to see
if the fence is tilted inward 45º to the table. If
an adjustment is necessary, loosen nuts (E) and
adjust bolts (F) until tips of bolts (F) contact
brackets (G).
5. Tilt the fence outward as far as possible and
using a combination square (45º), check to see
if the fence is tilted outward 45º to the table.
NOTE: 90º stop plate (B-Fig.10) must be rotated
up in order to tilt the fence outward. If an ad-
justment is necessary, loosen lock nut (A) Fig.
11, and adjust bolt (B) until head of bolt
(B) contacts back of fence.
Fig. 11
INFEED TABLE ADJUSTMENTS
To raise or lower the infeed table, loosen table
lock handle (A) Fig. 12, and move the table
raising and lowering hand lever (B), up or
down until the table is at the desired position
and tighten table lock handle (A).
NOTE: The table lockhandle (A) can be repo-
sitioned by pulling out the handle and repo-
sitioning it on the serrated nut located under
the handle. The depth of cut of the infeed
E N G L I S H •
table (position of table in relationship with the
cutting circle) can be read with the pointer and
scale (C).
Fig. 12
Positive stops are provided on the jointer to
limit the height and depth of the infeed ta-
ble. To adjust the stops, loosen two locknuts
(A) and (B) Fig. 13, and turn the two adjust-
ment bolts (C) and (D) as necessary. Retighten
locknuts (A) and (B). We recommend that the
height of the infeed table be adjusted so the
table at its highest point will be 1/2 mm below
the highest point of the knives. This is an im-
portant feature of your jointer which enables
you to rapidly position the infeed table for a
finish or final cut.
Fig. 13
OUTFEED TABLE ADJUSTMENTS
For most jointing operations the outfeed table
must be exactly level with the knives at their
highest point of revolution. To move the out-
feed table, loosen lockhandle (A) Fig. 14, and
move the table raising and lowering hand le-
ver (B) up or down until the table is level with
the knives. It may be necessary to adjust the
positive stops. Loosen the two locknuts (A) and
(B) Fig. 15, and the two adjusting bolts (C) and
(D) when moving the table up or down.
Fig. 14
U ser 's manual
Fig. 15
23
Tabla de contenido
