Wall-Mounting The Surround Speakers; Cabinet Maintenance; Speaker System Grille - Pioneer S-RS33TB Instrucciones De Operación

WALL-MOUNTING THE SURROUND
SPEAKERS
Before mounting
• Remember that the speaker system is heavy and that
its weight could cause the screws to work loose, or
the wall material to fail to support it, resulting in the
speaker falling. Make sure that the wall you intend to
mount the speakers on is strong enough to support
them. Do not mount on plywood or soft surface walls.
• Mounting screws are not supplied. Use screws
suitable for the wall material and support the weight
of the speaker.
Mounting screw
(not supplied)
5 mm to 7 mm
SECURING THE FRONT SPEAKERS
• Pass a commercially-available reinforced string
through the plastic catch to securely support the
speaker to the wall. Be sure that the wall to which you
fasten the speaker is strong enough to support the
weight of the speaker. After fastening the speaker,
make sure that it does not fall over.
• The speaker can incur damage in the event of a fall.
• Do not attach the plastic catch directly to the wall. It
should only be used in conjunction with reinforced
string to prevent the speaker from falling.
Reinforced strings
Pass and tie two reinforced strings through the plastic
catches, and fasten the speaker to the wall as shown
above.
• If you are unsure of the quality and strength of the
walls, consult a professional for advice.
• Pioneer is not responsible for any accidents or
damage that result from improper installation.
3.7 mm
9.3 mm
Plastic catches
Backside of speaker

CABINET MAINTENANCE

Use a polishing cloth or dry cloth to wipe off dust and dirt.
When the cabinet is very dirty, clean with a soft cloth
dipped in some neutral cleanser diluted five or six times
with water, and then wipe again with a dry cloth. Do not
use furniture wax or cleaners.
Never use thinners, benzine, insecticide sprays and other
chemicals on or near the cabinets, since these will
corrode the surfaces.

SPEAKER SYSTEM GRILLE

The speaker system grille cannot be removed. Do not try
to forcibly remove it since doing so may damage the
grille.
TROUBLESHOOTING
Symptom Possible cause
No sound • Bad speaker cord or
connection.
• Amplifier is off.
• Volume control is at zero.
Sound is • Extreme signal condition. • Turn down the
distorted.
Remedy
• Connect correctly or
replace cord.
• Turn on amplifier.
• Slowly turn up volume.
amplifier's output level
(volume, bass control,
bass boost) to lower the
level.
En
3