Removing Clogs - Kenmore 125.31140610 Manual De Uso

Always follow all safety precautions when
performing maintenance to the vacuum
cleaner.
WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
performing maintenance to the vacuum
cleaner. Failure to do so could result in
electrical shock or personal injury from
the vacuum cleaner suddenly starting.
If the vacuum cleaner does not seem to
have adequate suction, first check if the
dust bag is full or if a filter is clogged. See
CHANGING DUST BAG (page 15).
If the dust bag and filter areas are free of
clogs, check the clean-out port and the
extension hose. See the following sets of
instructions.
TO REMOVE CLOG FROM HOSE
1. Remove the hose handle from the hose
holder by twisting, and pulling straight up.
2. Plug in the vacuum cleaner and turn it on.

REMOVING CLOGS

3. Stretch the extension hose to maximum
length and then allow the hose to return to
its natural length.
4. Re-insert the hose into the original
storage position from which it was removed.
Press firmly to ensure correct placement.
5. Turn off and unplug the vacuum cleaner.
If the dust bag, filter
areas and the hose
areas are free of
clogs, disconnect the
Hose
nozzle hose from the
hose holder and check
the nozzle for
clogging.
1. Remove the nozzle
Hose
hose by twisting, and
Handle
pulling straight down.
Nozzle
Clean the agitator according to the
Hose
instructions in the AGITATOR CLEANING
(page 20).
Return the vacuum cleaner to the upright
position before plugging into an electrical
outlet.
- 19 -