How To Remove Odors From Refrigerator; Energy Saving Ideas; How To Remove And Replace Light Bulbs - Kenmore 596.65332600 Guía De Uso Y Cuidado

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

How to remove odors
from refrigerator
1. Remove all food.
2. Disconnect refrigerator.
3. Clean the following items–paying
special attention to crevices–using
the appropriate instructions in How to
Clean Your Refrigerator:
• Walls, floor and ceiling of cabinet
interior.
• Drawers, shelves and gaskets.
4. Wash and dry all bottles, containers
and jars. Discard spoiled or expired
items.
5. Wrap or store odor-causing foods in
tightly-sealed containers to prevent
reoccurring odors.
6. Connect power to refrigerator and
return food.
7. After 24 hours, check if odor has
been eliminated.
If odor is still present...
1. Remove drawers and place on top
shelf of refrigerator.
2. Pack refrigerator and freezer
sections–including doors–with
crumpled sheets of black and white
newspaper.
3. Place charcoal briquettes randomly
on crumpled newspaper in both
freezer and refrigerator
compartments.
4. Close doors and let stand 24–48 hours.
5. Repeat steps 5 through 7 above.
If odor was not eliminated, contact
Sears Service Center. Refer to back of
manual for phone number.
All manuals and user guides at all-guides.com

Energy saving ideas

­ Avoid overcrowding refrigerator
shelves. This reduces effectivity of air
circulation around food and causes
refrigerator to run longer.
­ Avoid adding too much warm food to
refrigerator at one time. This
overloads compartments and slows
rate of cooling.
­ Do not use aluminum foil, wax paper,
or paper toweling as shelf liners. This
decreases air flow and causes
refrigerator to run less efficiently.
­ A freezer that is
2
full runs most
3
efficiently.
­ Locate refrigerator in coolest part of
room. Avoid areas of direct sunlight,
or near heating ducts, registers, or
other heat producing appliances. If
this is not possible, isolate exterior by
using a section of cabinet or an
added layer of insulation.
­ Refer to section in Use and Care
Guide on temperature controls for
recommended control settings.
­ Clean door gaskets every three
months according to Use and Care
Guide instructions. This will assure
that door seals properly and
refrigerator runs efficiently.
­ Take time to organize items in
refrigerator to reduce time that door
is open.
­ Be sure your doors are closing
securely by leveling refrigerator as
instructed in your Use and Care
Guide.
­ Clean condenser coils off as
indicated in the Use and Care Guide
every 3 months. This will increase
energy efficiency and cooling
performance.
How to remove and
replace light bulbs
WARNING
To avoid electrical shock which can
cause severe personal injury or
death, disconnect power to
refrigerator before replacing light
bulb. After replacing light bulb,
connect power.
CAUTION
To avoid personal injury or property
damage, observe the following:
­ Allow light bulb to cool.
­ Wear gloves when replacing light
bulb.
FRESH FOOD
1. Slide shield toward
back of
compartment to
release from light
assembly.
2. Remove light bulbs.
3. Replace with appliance bulbs no
greater than 40 watts.
4. Replace light bulb
cover by inserting
tabs on light shield
into liner holes on
each side of light
assembly. Slide shield toward front of
refrigerator until it locks into place.
DO NOT force shield beyond locking
point. Doing so may damage light
shield.
FREEZER
1. Pinch rear tabs on
light cover and pull
straight down.
2. Remove light
bulb.
3. Replace bulb with appliance bulb no
greater than 40 watts.
4. Insert front tabs of light cover into
freezer liner and snap rear portion
over light assembly until rear tabs
engage.
A
B
17
Tabla de contenido
loading

Tabla de contenido