Specifications
EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
CARB
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Extended = 300 hours
Intermediate = 125 hours
Moderate = 50 hours
Engine
Single cylinder two-stroke engine
Displacement:
1.44 cu.in
23.6 cc
Bore:
1.34 in (34 mm)
Stroke:
1.02 in (26 mm)
MS 150 TC
Engine power to
1.3 HP (1.0 kW)
ISO 7293:
at 10,000 rpm
Idle speed:
3,000 rpm
Max. permissible
speed (with cutting
attachment):
12,800 rpm
Ignition System
Electronic (breakerless) magneto
ignition
Spark plug (resistor
type):
NGK CMR 6 H
Electrode gap:
0.020 in
(0.5 mm)
Fuel System
All position diaphragm carburetor with
integral fuel pump
Fuel tank capacity:
6.8 fl.oz (0.2 l)
Chain Lubrication
Fully automatic, speed-controlled oil
pump
Oil tank capacity:
5.1 fl.oz (0.15 l)
Weight
dry, without bar and chain
MS 150 TC:
5.7 lbs (2.6 kg)
Cutting Attachments
Recommended cutting attachments
conforming with applicable standards
when used on this model chain saw (see
the chapter on "Safety Precautions and
Working Techniques"):
Rollomatic E Mini guide bars
Reduced kickback STIHL guide bars
(with green label)
Bar lengths:
25, 30 cm (10, 12 in.)
Pitch:
1/4" P (6.35 mm)
Groove width: 1.1 mm (0.043 in)
Sprocket nose: 8-tooth
Actual cutting length will be less than
listed bar length.
Saw chain 1/4" P
Low kickback STIHL saw chain (with
green label)
Picco Micro 3 (71 PM3) Type 3670
Pitch:
1/4" P (6.35 mm)
Drive link gauge:
1.1 mm (0.043 in)
Chain sprocket
8-tooth for 1/4" P (spur sprocket)
Since new bar/chain combinations for
the MS 150 T may be developed after
publication of this manual, ask your
STIHL dealer for the latest STIHL
recommendations for use on the specific
model chain saw.
English
47