pony CLASSIC 110 Instalación Funcionamiento Y Mantenimiento página 25

E N G L I S H
d) The hot parts of the machine must be left to
cool (internal pipes, valves, the boiler, if
fitted, etc.) in order to avoid burns.
Only by observing all these precautions, and the
particular conditions relating to the individual
maintenance jobs, is it possible to carry out
maintenance work
complete safety. Remember 'you can never
be too careful'!
In order to make potential dangers more evident,
adhesive symbols have been applied to critical
parts of the machine: the meaning of these
symbols is explained in detail in the red section
at the beginning of this manual (Precautions for
the Safety of Operators and Property).
N.B. In any case, the maintenance work must
be undertaken only by competent personnel
who can take personal responsibility for their
own safety and that of other persons, animals
and property. The law, and in particular the
latest EU Directives, severely punish the
owner of a machine who allows maintenance
work to be carried out by non-qualified
personnel
Problem:
BREAKDOWNS IMMEDIATELY FOLLOWING INSTALLATION
1. The steam is wet after the
first few work cycles.
on the machine
BREAKDOWNS
1. Causes:
a) The
installed in the wrong place
b) The check valve has been
installed
direction, or has not been
installed at all;
c) Water in the steam feed
pipe.
d) Siphoning
condensation return pipe.
C H A P T E R 4
SIX MONTHLY / YEARLY
Clean
a)
condensation return pipe that, if dirty, stops
with
drainage and allows the siphoning back of
water.
b) Clean the air pipe from any impediment (dirty)
that stops the airflow during the ventilation
phase.
c) Check the wear of the board padding and, if
necessary, substitute it.
The board padding is considered a part
•
of the normal wear and tear since ironing
tends to matt the padding and decreases the
aspiration and steaming capacities of the
board.
d) Check the condition of all the labels and
plates
instructions). If they are in poor condition,
replace them.
Causes:
drain has been
in the wrong
in
Page 4-6
MAINTENANCE
the filter fitted
on the machine
Action:
1. Action:
a) Check that a steam trap
is mounted
condensation
or find a better place to
install it
b) Check the
flow direction, or install a
check valve.
c) Install a steam trap at the
end of the pipe between
the steam feed pipe and
the condensation return or
better upstream
machine.
the d) Eliminate the siphoning to
create a slope towards the
drain.
E N G L I S H
on the
(warnings and
to the
return pipe
check valve
of the