Tabla de contenido
Idiomas disponibles
Idiomas disponibles
E N G L I S H
b) Hold the iron and push at regular intervals the
push button until some steam comes out.
Verify that steam coming out from the iron is
not mixed with water, as in this case this
would mean that the temperature of the iron
is too low therefore wait for some minutes.
c) If necessary, control the quantity of steam
flux by means of the knob of steam valve.
N.B.: For use of the 'Electronic Iron', see the
specific manual relating to the iron.
USING THE HEATED ARM
FORMS
(SEE DRAWINGS PAGE 13-1)
Proceed in the following way:
a) Rotate the arm form that you want to use by
placing it in the work position.
b) Turn on the heating switch for the arm forms
"POS. 79". A thermostat on the inside of the
form controls the heating temperature.
c) To help the use of the aspirator on the arm
form, rotate the lever "POS. 48" counter-
clockwise until the aspirator is completely off
the board and then orient it to the arm form.
USING THE AIR/STEAM
SPOTTING GUN
(SEE DRAWING PAGE 13-1)
Proceed in the following way:
Place the part of the item to be cleaned on
a)
the end of the support and press vacuum
pedal "POS. 86".
b) Press the left button of the gun "POS. 36" to
release the steam. For the first few seconds
the steam is mixed with water. Therefore
discharge the gun for a few seconds until it
is well heated.
c) Distribute the jet of steam onto the stain with
the
gun.
Abundant
dissolves water-soluble stains.
d) If required dry the stained area spray stain
with compressed air by pressing the button
on the right of the gun.
Move the gun rapidly back and forth in a
•
zigzag motion to remove the dampness in
the stain with the air.
The strong, concentrated vacuum allows
•
rapid drying.
C H A P T E R 4
steaming
instantly
Page 4-5
SHUTTING DOWN OF THE
MACHINE
a) In case of machine with condensate
separator for finishing iron, close the two
gate fitted to the steam line "POS. 67" and
the condensation return "POS. 68" (see
page 10-11).
b) In
case
of
machine
spotting gun, close the ball tap assembly
on the air compression line "POS. 25" (see
page 10-10).
c) Turn off the electrical control board switch
and then the main switch fitted to the
electricity supply.
MAINTENANCE
The
following
instructions
importance in keeping the machine perfectly
efficient, ensuring its maximum performance,
and avoiding expensive down time.
The first part of this section is divided into
chapters according to periodic maintenance
schedules.
N.B.: The frequency indicated (weekly, monthly,
etc.) is indicative and refers to a machine that
operates under 'normal' conditions.
The individual customer has to decide on the
exact frequency of the maintenance work on the
basis of the following guidelines:
• The amount of work done by the machine;
• The amount of dust in the air;
• Other local working conditions.
All
the
maintenance
undertaken
with
the
switched off, and in particular:
a) The general electrical power switch must be
off and the plug removed from the socket.
b) For machine with condensate separator
for finishing iron, the two gate valves "POS.
67"
fitted
to
the
condensation return "POS. 68" (see page 10-
11) must be closed.
c) For machines with air/steam spotting
gun, the compressed air ball valve "POS. 25"
(see page 10-10) must be closed and all the
compressed air in the machine must be
discharged.
E N G L I S H
with
air/steam-
are
of
prime
operations
must
be
machine
completely
steam
line
and
the
Tabla de contenido
