Product Description - Nice mindy A01 Instrucciones Y Advertencias Para El Instalador

Warnings:
The MINDY A01 control unit has been designed for the control of a sin-
gle-phase asynchronous motor used for the automation of shutters,
overhead garage doors, gates, rolling shutters or awnings. Any other use
is improper and prohibited.

1) Product description

The Mindy A01 control unit enables the control of single-phase asyn-
chronous motors powered by the electrical mains, with "COMMON"
"OPEN" "CLOSE" type connections. It is designed for the automa-
tion of shutters, overhead garage doors, gates, rolling shutters or
awnings. The control unit incorporates a radio receiver operating at
a frequency of 433.92 MHz, which is compatible with the following
types of transmitters:
Table "A1" Transmitters
FLO1 - FLO2 - FLO4
FLO
VERY VE
FLO1R - FLO2R - FLO4R
VERY VR
FLOR
ERGO1 - ERGO4 - ERGO6
PLANO1 - PLANO4 - PLANO6 SMILO SM2 - SM4
C
B
A
C
2) Installation
!
The electrical systems and the automations must be
installed by qualified and experienced personnel in com-
pliance with current legislation. Before you proceed to
make any connections make sure that the mains power
supply is disconnected.
To proceed with the installation, secure the container as shown in fig-
ure 1.
When you drill a hole in the container for installation and wiring, take
the necessary precautions to guarantee the required IP protection
class. The wires must always be threaded from below.
2
D
L N +24 A/F P/B CH
P O
The motors must be equipped with electromechanical limit switches
designed to limit their movement. Keep in mind that these automation
systems must be installed by qualified personnel in compliance with cur-
rent laws and regulations.
As the type of coding is different, the first transmitter memorized also
determines the type of transmitters that may be memorized later.
Up to 254 transmitters can be memorized.
After each command, the motor is powered for the "working time"
(max 120 seconds) programmed during the installation stage.
An electric limit switch incorporated in the motor or automation sys-
tem stops the movement when the desired position is reached. The
control unit is equipped with a number of inputs used to activate
commands such as "step-by-step", "open", "close", as well as sig-
nals for the triggering of security devices such as photocells or stop
commands. The control unit can be connected to TTBUS systems.
Management of the radio codes is facilitated by the use of the SMU
programming unit.
E
F
G
H
I
L
T2
M
T1
N
A Line fuse (5A)
B "close" relay
C "open" relay
D low voltage transformer
E microprocessor
F connector for SMU programmer
G programming dip-switch
H "radio" LED
I "radio" pushbutton
L inputs LED
M terminal for radio aerial
N "step by step" pushbutton
O low voltage input terminals
P line and motor connection terminals