Start-Up; Programming; Description Of The Interface; Description Of Button Functions - Italtecnica Sirio Entry 230 Instrucciones Para El Uso

START-UP:

WARNING: do not allow the pump to run for long without water the first time it is
switched on otherwise the inverter will overheat! Prime the pump before switching on the
system.
Once all the electrical connections have been made and checked to ensure they are correct, close
the unit's cover and switch on the power.
The Sirio Entry is now in stand-by; in this mode (pump stationary) all the various parameters can
be set (see "programming" paragraph) before the system is started up.
To start up the pump, simply press the "on-off" button in the centre: The Sirio Entry will quit the
stand-by mode and the motor will start turning.
If the motor pump does not run or if it produces anomalous vibrations, check the right connection
of the pump and of its capacitor.
To facilitate pump filling, the "+" button on the main screen can be pressed to force the pump up
to top speed without the dry running protection feature cutting in.
After setting all the device parameters, write the data entered in the form found at the end of
this handbook for future reference and for guarantee purposes.

PROGRAMMING:

DESCRIPTION OF THE INTERFACE

1. Digital display, showing pressure, errors and configuration menus.
2. Motor pump start, stop and programming buttons.
3. Green warning light to signal line is live (LINE)
4. Red warning light to signal error conditions (FAILURE)
5. Yellow warning light to signal pump operation (PUMP ON)
DESCRIPTION OF THE BUTTONS
Left-hand arrow: this scrolls back through the menu pages
Right-hand arrow: this scrolls forwards through the menu pages
On-Off/Reset: this switches the device from stand-by to operation mode and resets the
unit in the event of alarms and/or errors.
"+" button: this increases the value of the parameter currently shown on the display, it
allows the pump to run at top speed under forced operation.
" "-" button: this decreases the value of the parameter currently shown on the display; it
displays the instantaneous current absorbed by the motor.
1
5
4
3
30
2